What will an Anker SOLIX Solarbank 3 E2700 Pro run? (EU)
A “1,200 W” power station is two numbers wearing one label. Watts are the ceiling on what you can switch on at once; watt-hours are how much energy is in the battery. The Anker SOLIX Solarbank 3 E2700 Pro holds 1,200 W and stores 2,688 Wh on the nameplate — and those two facts answer two different questions.
This page answers the first one. Anker SOLIX publishes no depth of discharge or inverter efficiency for this model, so there is no defensible usable-capacity figure, and this page will not turn the nameplate into hours.
The three numbers that decide everything else
Continuous output1,200 W
Official spec · verified 2026-08-01 · high confidence
Surge ceiling1,200 W
Derived by WattPair · low confidence
The brand publishes no surge rating. This is a conservative floor taken from the continuous output — an inverter cannot surge below what it sustains — and is not a manufacturer specification.
Nominal capacity2,688 Wh
Official spec · verified 2026-08-01 · high confidence
No usable-capacity figure for this model
The brand publishes a nameplate watt-hour number and nothing about depth of discharge or inverter efficiency. Dividing the nameplate by a load would be wrong by 20–35%, so this page shows the nameplate for what it is and refuses to turn it into hours.
Missing: station.usable_capacity_wh
official · verified 2026-08-01 · EU unit
What Anker SOLIX Solarbank 3 E2700 Pro runs
Every row is a live calculation against this machine's continuous output, surge ceiling and
inverter waveform — running watts, start-up inrush and duty cycle on the appliance side. Of 30 appliance profiles, 10 run, 4 are a tight fit and 16 are out of reach. The percentage is the
load as a share of continuous output; anything past 82% drops out of the green.
One caveat that applies to every row: Anker SOLIX publishes no surge rating for this
model, so each start-up check runs against the continuous output as a conservative floor.
Real inverters usually manage 1.5–2× that, so a row held back
by the surge check may well be fine in practice — we will not say so until the
manufacturer does.
The binding constraint is voltage, not watts: open-circuit voltage RISES as it gets colder, and
an array that is fine at noon can be over the MPPT ceiling at dawn. Each row is the engine's
largest legal array for this station, with Voc corrected to -10 °C ambient
. Only panels whose datasheet publishes a voltage temperature coefficient are evaluated — the
others cannot be corrected, and an under-corrected array is what destroys an MPPT input.
Jackery SolarSaga 100 Air 6 × 100 W · 6 in parallel · 600 W array
Voc at the design minimum: 32.3 V
Panel connector: DC8020Needs a dc8mm-to-mc4 adapter.
Renogy 100W 12V Monocrystalline Solar Panel (Compact Design) 12 × 100 W · 2S6P · 1200 W array
Voc at the design minimum: 53.4 V
Panel connector: Solar Connectors
Renogy 200W 12V Monocrystalline Solar Panel 3 × 200 W · 3 in parallel · 600 W array
Voc at the design minimum: 29.6 V
Panel connector: MC4
Every field we hold on this machine
Each figure carries the tier it came from and the date it was checked. A blank is never left
blank: a field the manufacturer does not publish says so, and a field two manufacturer sources
disagree about says that instead of picking one.
AC output
What the inverter can hold, what it can start, and what shape the wave is.
Continuous output1,200 W Official spec · verified 2026-08-01 · high confidence
Surge ceiling1,200 W Derived by WattPair · low confidence
The brand publishes no surge rating. This is a conservative floor taken from the continuous output — an inverter cannot surge below what it sustains — and is not a manufacturer specification.
Surge durationNot published by the manufacturer no figure to date
Boost modeNo Official spec · verified 2026-08-01 · high confidence
Boost outputNot published by the manufacturer no figure to date
The verdict engine never counts boost output as continuous output: it works by dropping voltage and can fail on motors and compressors.
Inverter waveformNot published by the manufacturer no figure to date
Inverter efficiencyNot published by the manufacturer no figure to date
AC voltageNot published by the manufacturer no figure to date
AC frequencyNot published by the manufacturer no figure to date
Outlet standardSchuko Official spec · verified 2026-08-01 · high confidence
UPS switchoverNot published by the manufacturer no figure to date
Idle drawNot published by the manufacturer no figure to date
What the machine consumes just being switched on. It sits in the runtime denominator, and a brand that does not publish it makes every runtime optimistic.
Battery and energy
The nameplate, what is actually retrievable from it, and how long the cells last.
Nominal capacity2,688 Wh Official spec · verified 2026-08-01 · high confidence
Usable capacityNot published by the manufacturer no figure to date
Not published, and not derivable: the brand states neither depth of discharge nor inverter efficiency for this model.
Depth of dischargeNot published by the manufacturer no figure to date
ChemistryLiFePO4 (LFP) Official spec · verified 2026-08-01 · high confidence
Cycle lifeNot published by the manufacturer no figure to date
Capacity at end of cycle lifeNot published by the manufacturer no figure to date
Warranty10 years Official spec · verified 2026-08-01 · high confidence
Discharge temperature (min)-20 °C Official spec · verified 2026-08-01 · high confidence
Discharge temperature (max)55 °C Official spec · verified 2026-08-01 · high confidence
Charge temperature (min)-20 °C Official spec · verified 2026-08-01 · high confidence
Charging and expansion
How fast it refills from the wall, and whether more battery can be bolted on.
AC input (max)1,200 W Official spec · verified 2026-08-01 · high confidence
Wall charge, 0–100%Not published by the manufacturer no figure to date
Wall charge, 0–80%Not published by the manufacturer no figure to date
Car input (max)Not published by the manufacturer no figure to date
Combined input (max)3,600 W Official spec · verified 2026-08-01 · high confidence
ExpandableYes Official spec · verified 2026-08-01 · high confidence
Capacity with expansion16,000 Wh Official spec · verified 2026-08-01 · high confidence
Extra batteries supported5 Official spec · verified 2026-08-01 · high confidence
Solar input
The window an array has to land inside. Voltage is the constraint that burns hardware.
Solar input (max)3,600 W Official spec · verified 2026-08-01 · high confidence
MPPT window (min)11 V Official spec · verified 2026-08-01 · high confidence
MPPT window (max)60 V Official spec · verified 2026-08-01 · high confidence
Input current (max)32 A Official spec · verified 2026-08-01 · high confidence
Solar connectorMC4 Official spec · verified 2026-08-01 · high confidence
Physical and travel
Weight, size, noise — and whether an airline will let it on board.
Weight29.2 kg Official spec · verified 2026-08-01 · high confidence
Length460 mm Official spec · verified 2026-08-01 · high confidence
Width279 mm Official spec · verified 2026-08-01 · high confidence
Height254 mm Official spec · verified 2026-08-01 · high confidence
NoiseNot published by the manufacturer no figure to date
App controlYes Official spec · verified 2026-08-01 · high confidence
ConnectivityBluetooth, Wi-Fi Official spec · verified 2026-08-01 · high confidence
Capacity for airline rules2,688 Wh Official spec · verified 2026-08-01 · high confidence
IATA lets passengers carry lithium batteries up to 100 Wh freely and 100–160 Wh with airline approval. Above that, no passenger aircraft.
Where to buy
Where to buy the Anker SOLIX Solarbank 3 E2700 Pro
Each link goes to that machine's own record. Every record holds the same fields in the
same order and states the same tier and date beside each one, so two of them read
side by side compare cleanly.
Where to go next
Questions people ask about this machine
Will an Anker SOLIX Solarbank 3 E2700 Pro run a full-size refrigerator?
Yes. Against the EU record, the full-size refrigerator draws 55 W running · 286 W at start-up — 4.6% of this machine's continuous output. That verdict is a calculation from running watts, start-up surge and inverter waveform, not a lookup, and the full working is one click away in the table above.
Why can't an Anker SOLIX Solarbank 3 E2700 Pro run an electric space heater (1500 W)?
On the EU record the binding constraint is the continuous output. The electric space heater (1500 W) needs 1,500 W running · 1,500 W at start-up, and at 125% of continuous output there is no headroom to give. No accessory fixes this one — it takes a machine with a bigger inverter.
How long will an Anker SOLIX Solarbank 3 E2700 Pro run my appliances?
We will not put a number on it, and that is deliberate. A runtime needs a usable-capacity figure, and Anker SOLIX publishes no depth of discharge or inverter efficiency for this model — only a nameplate watt-hour rating. Dividing that nameplate by your load produces a confident-looking figure that is typically 20–35% too high. What this page gives you instead is every load's energy rate in watt-hours per hour, which needs no battery figure at all and is the number you actually size against.
Can you take an Anker SOLIX Solarbank 3 E2700 Pro on a plane?
No. At 2,688 Wh it is far above the 160 Wh ceiling that airlines apply to lithium batteries in the cabin, and lithium batteries of this size are not accepted in checked baggage either. The 100 Wh / 160 Wh thresholds come from the IATA dangerous-goods rules that carriers implement; check your airline before travelling, because the approval step above 100 Wh is theirs to give.