What will a BLUETTI Elite 30 V2 run, and for how long? (EU 230 V)
A “600 W” power station is two numbers wearing one label. Watts are the ceiling on what you can switch on at once; watt-hours are how much energy is in the battery. The BLUETTI Elite 30 V2 holds 600 W and stores 288 Wh on the nameplate — and those two facts answer two different questions.
This page answers both. The runtimes below divide a usable-capacity figure derived from BLUETTI's own published depth of discharge and inverter efficiency, with the machine's idle draw in the denominator — not the nameplate.
The three numbers that decide everything else
Continuous output600 W
Official spec · verified 2026-08-01 · high confidence
Surge ceiling600 W
Derived by WattPair · low confidence
The brand publishes no surge rating. This is a conservative floor taken from the continuous output — an inverter cannot surge below what it sustains — and is not a manufacturer specification.
Usable capacity246.2 Wh
Derived from official coefficients · verified 2026-08-01 · medium confidence
The arithmetic:288 Wh nameplate × 95% depth of discharge × 90% inverter efficiency = 246.2 Wh
official · verified 2026-08-01 · EU 230 V unit
What BLUETTI Elite 30 V2 runs
Every row is a live calculation against this machine's continuous output, surge ceiling and
inverter waveform — running watts, start-up inrush and duty cycle on the appliance side. Of 30 appliance profiles, 12 run, 2 are a tight fit and 16 are out of reach. The percentage is the
load as a share of continuous output; anything past 82% drops out of the green.
One caveat that applies to every row: BLUETTI publishes no surge rating for this
model, so each start-up check runs against the continuous output as a conservative floor.
Real inverters usually manage 1.5–2× that, so a row held back
by the surge check may well be fine in practice — we will not say so until the
manufacturer does.
The binding constraint is voltage, not watts: open-circuit voltage RISES as it gets colder, and
an array that is fine at noon can be over the MPPT ceiling at dawn. Each row is the engine's
largest legal array for this station, with Voc corrected to -10 °C ambient
. Only panels whose datasheet publishes a voltage temperature coefficient are evaluated — the
others cannot be corrected, and an under-corrected array is what destroys an MPPT input.
Jackery SolarSaga 100 AirNo legal arrangement on this station.
Voc at the design minimum: 32.3 V
Panel connector: DC8020Blocked by cold Voc.
Renogy 100W 12V Monocrystalline Solar Panel (Compact Design) 1 × 100 W · single panel · 100 W array
Voc at the design minimum: 26.7 V
Panel connector: Solar ConnectorsLegal, with a caution on cold Voc.
Renogy 200W 12V Monocrystalline Solar PanelNo legal arrangement on this station.
Voc at the design minimum: 29.6 V
Panel connector: MC4Blocked by cold Voc.
Every field we hold on this machine
Each figure carries the tier it came from and the date it was checked. A blank is never left
blank: a field the manufacturer does not publish says so, and a field two manufacturer sources
disagree about says that instead of picking one.
AC output
What the inverter can hold, what it can start, and what shape the wave is.
Continuous output600 W Official spec · verified 2026-08-01 · high confidence
Surge ceiling600 W Derived by WattPair · low confidence
The brand publishes no surge rating. This is a conservative floor taken from the continuous output — an inverter cannot surge below what it sustains — and is not a manufacturer specification.
Surge durationNot published by the manufacturer no figure to date
Boost modeNot published by the manufacturer no figure to date
Sold as “Power Lifting”.
Boost outputNot published by the manufacturer no figure to date
The verdict engine never counts boost output as continuous output: it works by dropping voltage and can fail on motors and compressors.
Inverter waveformPure sine wave Official spec · verified 2026-08-01 · high confidence
Inverter efficiency90% Official spec · verified 2026-08-01 · medium confidence
AC voltage230 V Official spec · verified 2026-08-01 · high confidence
AC frequency50 Hz Official spec · verified 2026-08-01 · medium confidence
Outlet standardSchuko CEE 7/3 Official spec · verified 2026-08-01 · medium confidence
UPS switchover10 ms Official spec · verified 2026-08-01 · high confidence
Idle draw9 W Official spec · verified 2026-08-01 · medium confidence
What the machine consumes just being switched on. It sits in the runtime denominator, and a brand that does not publish it makes every runtime optimistic.
Battery and energy
The nameplate, what is actually retrievable from it, and how long the cells last.
Nominal capacity288 Wh Official spec · verified 2026-08-01 · high confidence
Usable capacity246.2 Wh Derived from official coefficients · verified 2026-08-01 · medium confidence
The arithmetic:288 Wh nameplate × 95% depth of discharge × 90% inverter efficiency = 246.2 Wh
BLUETTI publishes the coefficients but not this figure, so it is computed rather than copied — which is why its confidence is capped below the specs around it.
Depth of discharge95% Official spec · verified 2026-08-01 · high confidence
ChemistryLiFePO4 (LFP) Official spec · verified 2026-08-01 · high confidence
Cycle life3,000 cycles Official spec · verified 2026-08-01 · high confidence
Capacity at end of cycle life80% Official spec · verified 2026-08-01 · high confidence
Warranty5 years Official spec · verified 2026-08-01 · high confidence
Discharge temperature (min)-20 °C Official spec · verified 2026-08-01 · high confidence
Discharge temperature (max)40 °C Official spec · verified 2026-08-01 · high confidence
Charge temperature (min)0 °C Official spec · verified 2026-08-01 · high confidence
Charging and expansion
How fast it refills from the wall, and whether more battery can be bolted on.
AC input (max)380 W Official spec · verified 2026-08-01 · high confidence
Wall charge, 0–100%Not published by the manufacturer no figure to date
Wall charge, 0–80%45 min Official spec · verified 2026-08-01 · high confidence
Car input (max)Not published by the manufacturer no figure to date
Combined input (max)380 W Official spec · verified 2026-08-01 · high confidence
ExpandableNo Official spec · verified 2026-08-01 · high confidence
Capacity with expansionNot applicable to this model no figure to date
Extra batteries supportedNot applicable to this model no figure to date
Solar input
The window an array has to land inside. Voltage is the constraint that burns hardware.
Solar input (max)200 W Official spec · verified 2026-08-01 · high confidence
MPPT window (min)12 V Official spec · verified 2026-08-01 · high confidence
MPPT window (max)28 V Official spec · verified 2026-08-01 · high confidence
Input current (max)10 A Official spec · verified 2026-08-01 · high confidence
Solar connectorXT60 Official spec · verified 2026-08-01 · high confidence
Physical and travel
Weight, size, noise — and whether an airline will let it on board.
Weight4.3 kg Official spec · verified 2026-08-01 · high confidence
Length250 mm Official spec · verified 2026-08-01 · high confidence
Width178 mm Official spec · verified 2026-08-01 · high confidence
Height167.5 mm Official spec · verified 2026-08-01 · high confidence
NoiseNot published by the manufacturer no figure to date
App controlYes Official spec · verified 2026-08-01 · high confidence
ConnectivityNot published by the manufacturer no figure to date
Capacity for airline rules288 Wh Official spec · verified 2026-08-01 · high confidence
IATA lets passengers carry lithium batteries up to 100 Wh freely and 100–160 Wh with airline approval. Above that, no passenger aircraft.
Each link goes to that machine's own record. Every record holds the same fields in the
same order and states the same tier and date beside each one, so two of them read
side by side compare cleanly.
Where to go next
Questions people ask about this machine
Will a BLUETTI Elite 30 V2 run a full-size refrigerator?
Yes. Against the EU 230 V record, the full-size refrigerator draws 55 W running · 286 W at start-up — 9.2% of this machine's continuous output, and the pair runs for about 4.4 h. That verdict is a calculation from running watts, start-up surge and inverter waveform, not a lookup, and the full working is one click away in the table above.
Why can't a BLUETTI Elite 30 V2 run an electric space heater (1500 W)?
On the EU 230 V record the binding constraint is the continuous output. The electric space heater (1500 W) needs 1,500 W running · 1,500 W at start-up, and at 250% of continuous output there is no headroom to give. No accessory fixes this one — it takes a machine with a bigger inverter.
How long does a BLUETTI Elite 30 V2 last?
It depends entirely on the load, and that is the part most pages skip. On our figures the BLUETTI Elite 30 V2 runs a 12V portable fridge/freezer for about 2.5 h, and an air fryer for about 0.1 h. Those hours come from a usable-capacity figure derived from BLUETTI's published depth of discharge and inverter efficiency, with the machine's own idle draw in the denominator — not from dividing the nameplate watt-hours by a label wattage.
Can you take a BLUETTI Elite 30 V2 on a plane?
No. At 288 Wh it is far above the 160 Wh ceiling that airlines apply to lithium batteries in the cabin, and lithium batteries of this size are not accepted in checked baggage either. The 100 Wh / 160 Wh thresholds come from the IATA dangerous-goods rules that carriers implement; check your airline before travelling, because the approval step above 100 Wh is theirs to give.
Is the EU BLUETTI Elite 30 V2 the same as the US one?
No, and we keep them as two separate records for that reason. This one is built for 230 V mains and the US version for 120 V, which changes the outlets, the certifications and the charging figures. Where the brand publishes different numbers for the two, this page shows only the ones for the EU 230 V version.