Can a Jackery Explorer 1000 v2 run a sump pump? (US 120 V)
Yes, it runs it — an input is missing see why below ↓
Every check passes. What this page will not do is turn a nameplate watt-hour rating into hours — see the evidence below for why.
Derived from official coefficients + Derived by WattPairverified 2026-08-08US 120 V unit × sump pump
Running720 Wof1,500 Wcontinuous output
Start-up2,645 Wof3,000 Wsurge ceiling
0 – 3,000 W across the rails above
Two numbers decide this, and readers use them interchangeably: watts are the ceiling on what the inverter holds at any instant, watt-hours are how much energy the battery holds. A machine can have plenty of one and not enough of the other.
The verdict is a calculation, not a lookup. What it will not do is print a runtime, and the reason is specific: the calculation is missing an input, and nothing is estimated to fill the gap.
Where those numbers come from
A blank is never left blank. A field we have found no figure for says so, and a field whose sources disagree — two documents, or one document with itself — says that instead of picking one.
Energy rate instead of a runtime
720 Wh per hour while it is actually runningNo runtime in hours here: we do not hold a duty cycle for this load, and nothing is estimated to fill the gap.
What a sump pump demands
The engine checked 2,645 W — where a record publishes both an absolute inrush and a multiple of running power, the more demanding of the two is used rather than the flattering one.
The inverter is loaded to 1,043 VA — 720 W ÷ 0.69 — which is the quantity its ceiling is actually measured against.
Start-up figure Manufacturer nameplate (locked-rotor)
The start-up figure is the manufacturer’s own locked-rotor rating, off a spec sheet for a real model in this class — not a category multiple. Where a standards table and the nameplate disagree, this library uses the nameplate: the standards figure is a selection envelope for breakers and controllers, and sizing a battery to it over-specifies the machine by two to four times.
What the Jackery Explorer 1000 v2 offers
The arithmetic: 1,070 Wh nameplate × 80% published capacity coefficient = 856 Wh
Jackery publishes the coefficients but not this figure, so it is computed rather than copied.
What the machine consumes just being switched on. It sits in the runtime denominator alongside the load.
Where to buy
Where to buy the Jackery Explorer 1000 v2
Prices checked 2026-08-17
If this is not the pairing
BLUETTI Elite 100 V2 (US 120 V) reaches the same conclusion on a sump pump at 1,800 W continuous, and it is $499. Cheaper is only cheaper when the answer is the same — this one is. See that pairing →
The same load on the machines beside it
The same machine on the loads beside it
Where to go next
A sump pump has a dedicated guide: the same records this page computes from, worked through in prose with room for the reasoning a table can only summarise — Can a power station really keep my sump pump running through a storm?