Will an EcoFlow DELTA Pro 3 run a CPAP machine? (US 120 V)

Yes, it runs it no usable-capacity figure see why below ↓

Every check passes. Nothing here has a locked rotor to publish an inrush figure for, so the absence of one is a fact about the hardware rather than a hole in the library.

Official spec + Derived by WattPairverified 2026-08-08US 120 V unit × CPAP machine

Nominal capacity 4,096 Wh
Surge headroom 10×+

Running22 Wof4,000 Wcontinuous output

0 – 4,000 W across the rails above

No start-up rail: this load has no locked rotor to publish an inrush for, so no start-up demand was checked.

Two numbers decide this, and readers use them interchangeably: watts are the ceiling on what the inverter holds at any instant, watt-hours are how much energy the battery holds. A machine can have plenty of one and not enough of the other.

The verdict is a calculation, not a lookup. What it will not do is print a runtime, and the reason is specific: we read 4 of EcoFlow’s own published documents on 2026-08-08 and found no depth of discharge or inverter efficiency for the US 120 V build in them, so there is no usable-capacity figure to divide.

This page answers an electrical question, not a medical one.

Where this page puts hours on a pairing, that figure is how long a power station’s battery lasts running this machine’s wattage — an electricity calculation, not a judgment about whether a break in therapy is safe. A small watt figure alone does not settle a verdict here either: this machine also carries a documented waveform requirement, and a station with no waveform on record is held at a tight fit regardless of how easily it clears the watts.

Where a verdict below reads a tight fit — the amber triangle on a row in the list of stations — read it as don’t rely on this pairing, whatever reason the row gives for that particular verdict, and not as a compromise likely to hold anyway. That state means the same thing here however it was arrived at: this site cannot clear the pairing with confidence, and that isn’t a passing grade with a footnote. Where a row says a check could not be run at all, that is a weaker claim than a near miss, not a stronger one.

What to do about a power interruption during therapy is a question for a clinician, the durable medical equipment (DME) supplier who set the machine up, or the manufacturer’s own guidance for it — not for this site. For the electricity side of an outage plan, this page can help: what a station needs to run this machine at all, and — where both makers publish enough to work it out — how long a given battery keeps it running.

Where those numbers come from

A blank is never left blank. A field we have found no figure for says so, and a field whose sources disagree — two documents, or one document with itself — says that instead of picking one.

No usable-capacity figure for this machine

EcoFlow states a nameplate watt-hour number for it, and we read 4 of EcoFlow’s own published documents on 2026-08-08 and found no depth of discharge or inverter efficiency for the US 120 V build in them. Dividing the nameplate by this load would be wrong by 20–35% in the flattering direction, so this page shows the nameplate for what it is and refuses to turn it into hours.

Missing: station.usable_capacity_wh

Energy rate instead of a runtime

22 Wh per hour averaged over this load’s duty cycle

This number needs no battery figure at all, which is why this page can give it when it cannot give hours. Divide any usable-capacity figure you trust by it and you have your own runtime, with our arithmetic visible instead of hidden.

What a CPAP machine demands

Running power 22 W Official spec · verified 2026-08-01 · high confidence
Duty cycle 100% Official spec · verified 2026-08-01 · high confidence
Power factor 0.50 Official spec · verified 2026-08-01 · high confidence

The inverter is loaded to 44 VA — 22 W ÷ 0.50 — which is the quantity its ceiling is actually measured against.

Pure sine wave required Yes Official spec · verified 2026-08-01 · high confidence

What the EcoFlow DELTA Pro 3 offers

Continuous output 4,000 W Official spec · verified 2026-08-01 · high confidence
Surge ceiling 8,000 W Official spec · verified 2026-08-01 · high confidence
Nominal capacity 4,096 Wh Official spec · verified 2026-08-01 · high confidence
Inverter waveform Pure sine wave Official spec · verified 2026-08-01 · high confidence

Where to buy

Where to buy the EcoFlow DELTA Pro 3

Prices checked 2026-08-17

EcoFlow Official Store (US) $2,799 View →

If this is not the pairing

Same verdict, less money

BLUETTI Elite 30 V2 (US 120 V) reaches the same conclusion on a CPAP machine at 600 W continuous, and it is $239. Cheaper is only cheaper when the answer is the same — this one is. See that pairing →

The same load on the machines beside it

The same machine on the loads beside it

Where to go next

From the Knowledge channel

A CPAP machine has a dedicated guide: the same records this page computes from, worked through in prose with room for the reasoning a table can only summarise — How many nights can a power station run my CPAP?

Questions people ask about this pairing

Will an EcoFlow DELTA Pro 3 run a CPAP machine?
Yes. 22 W of running draw against 4,000 W of continuous output — 0.5% of it. The verdict is computed from running watts, and inverter waveform — the working is in the evidence section above.
How long will an EcoFlow DELTA Pro 3 run a CPAP machine?
We will not put a number on it, and that is a finding rather than a gap. We read 4 of EcoFlow’s own published documents on 2026-08-08 and found no depth of discharge and no inverter efficiency for the US 120 V build in them. What it does state is a nameplate watt-hour rating. Dividing that nameplate by this load produces a figure that is typically 20–35% too high while looking exactly as authoritative as a real one. What this page gives instead is the load's energy rate in watt-hours per hour, which needs no battery figure at all.
Why is there no runtime on a page that says yes?
Because "yes it runs it" and "yes for this long" are two different claims with two different evidence requirements, and this machine only supports the first. The verdict needs a continuous rating and a surge ceiling, which EcoFlow publishes. Hours need a usable-capacity figure, which it does not. Twenty of the twenty-six machines in our library are in that position, and the alternative — nameplate watt-hours divided by label watts — is the single most common wrong number on this topic.

Runs it EcoFlow DELTA Pro 3 · from $2,799

Check price →